Vertex Standard VXR-7000 Service Manual page 13

TX Pwr: Transmitter Power Output Selection
This parameter selects the desired power output from the
VXR-7000 on the current channel. The available values
are HIGH and LOW.
Press the [S ] bar to select "Hi" or "Lo."
PACE
TOT Mute: Enable/disable the TOT (Time-Out Timer)
beep monitoring
When this parameter is set to "on," the alert beep will
sound from the front panel speaker before the repeater
turns itself off.
RptTOT Use: Enable/disable the Time-Out Timer while
operating in the repeater mode
Press the [S ] bar to toggle the Repeater TOT selects
PACE
"yes" or "no."
The TOT time is determined via dealer programming.
Operating Manual Reprint
RptTOT Beep: Enable/disable the TOT beep Transmis-
sion
Press the [S ] bar to toggle the TOT beep selects "yes"
PACE
or "no."
When this parameter is set to "yes," the alert beep will be
sent out on the air before the repeater turns itself off, while
oprtating in the "REPEATER" mode.
RPT HT: Enable/disable the Repeater Hang-on Timer
Press the [S ] bar to toggle the Repeater Hang-on Timer
PACE
selects "yes" or "no."
When this parameter is set to "yes," the repeater will re-
main keyed for a desired seconds after a receiving carrier
is dropped.
The Hang-up time is determined via dealer programming.
RPT GT: Enable/disable the Repeater Guard
When this parameter is set to "yes," the transmitter in-
hibit few second before the repeater is unkeyed.
The inhibit time is determined via dealer programming.
13