Alamo Industrial Great White M8000MD Operator's Manual page 52

Before operating the snow blower recheck that all
fasteners, nuts, bolts, screws and cotter pins are in
place and all bolts are torqued to specification.
Check Roller chains for tightness and adjust the idler
sprockets accordingly. ALWAYS keep roller chain tight.
See Cummins Engine Manual for instructions related
to QSB220 Powerunit.
WARNING!
Only operate the snow blower in conditions were you have clear visibility in
daylight or with adequate artificial lighting. Never snow blow in darkness or in
conditions where you cannot clearly see at least 100 yards in front and to the
sides of the Power Unit and Snow Blower. Make sure that you can clearly see
and identify passersby, steep slopes, ditches, drop-offs, overhead obstructions,
power lines, debris and foreign objects. If you are unable to clearly see these
types of items, discontinue snow blowing.
DANGER! DO NOT operate this Implement on a Power Unit that is not properly maintained.
Should a mechanical or Power Unit control failure occur while operating,
immediately shut down the Power Unit and perform repairs before resuming
operation. Serious injury and possible death could occur from not maintaining
this Implement and Power Unit in good operating condition.
CAUTION! If removing snow from other than paved or hard surfaced areas, move deflector to the
low position to minimize the distance that gravel or foreign material is ejected.
M-8000MD 12/04
.
© 2004 Alamo Group Inc
OPERATION
See Maintenance Section.
Remove lid to grease
Internal Bearings
(SSB-1)
Operation Section 4-11
FIGURE 13
(SPU-38)