Alamo Industrial Great White M8000MD Operator's Manual page 48

Grease the blower completely as per the lubrication
guide.
Ensure chute ring is greased and rotating freely
Inspect that all bolts and screws are in position
and are properly torqued.
Check blade wear and if worn reverse it or replace.
Check the engine air cleaner.
Check the engine oil level and the coolant level.
Check the hydraulic oil level and add if needed.
Use 10wt. hydraulic oil or equivalent, ISO32.
Use correct diesel fuel for cold weather conditions.
Grease the spouts generously with a silicone-based
grease.
Make sure that control cord is securely attached
in the loaders cab and the wiring harness is clear
of any pinch points. Always disconnect the wiring
harness from the snow blower first when
disconnecting from machine.
Perform scheduled lubrication as specified in the
maintenance section.
Inspect the oil level and condition of oil reservoir
and replenish if needed. (Add specific type oil if
low)
Ensure there are no oil leaks and fittings are
properly connected and tightened.
NOTE: Refer to original manufacturers engine manual
for maintenance on engine repair.
M-8000MD 12/04
.
© 2004 Alamo Group Inc
OPERATION
Operation Section 4-7
Fans
FIGURE 6
Oil
Reservoir
FIGURE 7