1 Remove the large stand off from both PTO30 units - by removing 2
screws per side.
Large standoff
Note: Removing a burner from one of the units will make it easier to stack
the burners.
This step is recommended - but not required.
2) Remove the burner from one of the units - by removing 4 screws in loca-
tions shown below.
3) Bend fl ange 90º downward until it is fl at.
Do this on each burner only on end shown below.
Bend fl ange till fl at
Regency Plateau™ PTO30 Outdoor Gas Fireplace
PTO60 ASSEMBLY
4) Reinstall burner.
5) Line the two units up end to end. Stack the fl attened burner fl anges
(from previous step) one over top of the other. Create a fl at surface
across both burners.
6) Install units together into framing. Secure in place with nailing strips.
Bend fl ange till fl at
INSTALLATION
17