Table of Contents
Advertisement
Before installation,stainless steel must be handled and cleaned as per instructions noted below:
• Stainless table top must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
•Stainless table top will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on table top which you will be unable to remove.
Not protected by product warranty.
1) Remove knockouts from both ends of unit with pliers as shown below.
2) Place table top over completed unit.
Note: Unit shown below is not completed
3) Place end caps over both pilots at either end to complete installation.
Note: 2 caps remain - these may be discarded or kept as spare parts.
End Cap
Regency Plateau™ PTO30 Outdoor Gas Fireplace
PTO60 TABLE TOP INSTALLATION
Stainless Steel Table Top
4) To remove - reverse steps 3-2.
INSTALLATION
Final Install
19
Advertisement
Table of Contents
