Programming The Ip Telephones; Assigning The Ip Addressing Information - Panasonic KX-NCP500 Manual

4.4 Programming the IP Telephones

4.4.1 Assigning the IP Addressing Information

The IP address of an IP telephone, the subnet mask address, the default gateway address, and the PBX IP
address must be assigned to the IP telephone before it can be used on the network. These IP addressing
information can be assigned in the following ways:
Note
For details for the KX-NT400, refer to the Operating Instructions of the KX-NT400.
For IP-PTs
1.
Using a DHCP server when the IP-PT is on the same LAN with the PBX
The DHCP server automatically assigns the IP address of the IP-PT, the subnet mask address, and the
default gateway address to the IP-PT.
The PBX IP address can also be assigned automatically to the IP-PT in process of being registered to the
PBX. For details about registering the IP-PT, refer to "4.5.1 Registering IP Telephones".
2.
Using a DHCP server when the IP-PT is on the remote office LAN
While the DHCP server automatically assigns the IP address of the IP-PT, the subnet mask address, and
the default gateway address to the IP-PT, only the PBX IP address must be assigned manually.
Follow the procedure below to assign the PBX IP address.
If you need to set VLAN parameters, follow the procedure described in "4.4.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
Document Version 2009-12
4.4.1 Assigning the IP Addressing Information
IP Networking Guide 47