Panasonic KX-NCP500 Manual page 45

When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
In the IP Address for IPCMPR Card box, type the
IP address of the IPCMPR card.
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP card.
d.
In the Subnet Mask box, type the subnet mask
address of the network.
e.
In the Default Gateway box, type the IP address
of the default gateway.
f.
Click Apply.
After Quick Setup is completed, if the IP addressing information was not changed and a V-IPEXT card
was installed during setup, the IP-PT registration screen is displayed. For information on registering
IP-PTs to the PBX, refer to "Registration of IP-PTs" in "4.5.1 Registering IP Telephones".
Programming from the system menu
1. The IP addressing information for the IPCMPR card
can also be assigned from the system menu.
a.
Under Configuration, click Slot.
b.
Move the mouse pointer over the IPCMPR card. A
menu will be shown under the mouse pointer.
c.
Click Card Property.
2. When using a DHCP server:
a.
Click the LAN Setting tab, then select Enable for
the DHCP Client setting.
b.
Click Apply.
When not using a DHCP server:
a.
Click the LAN Setting tab, then select Disable for
the DHCP Client setting.
b.
In the IP Address for IPCMPR Card box, type the
IP address of the IPCMPR card.
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP card.
d.
In the Subnet Mask box, type the subnet mask
address of the network.
e.
In the Default Gateway box, type the IP address
of the default gateway.
f.
Click Apply.
Document Version 2009-12
*1
*2
*3
*4
*1
*2
*3
*4
4.3.1 Assigning the IP Addressing Information
IP Networking Guide 45