Epson LG1-1070 Service Manual page 74

REV.-B
3.2.5.6 Removing and Disassembling the FRAME, MAIN, RIGHT
1. Remove the PRINTER MECHANISM from the HOUSING ASSY., LOWER (see Section 3.2.4).
Remove the PLATEN from the PRINTER MECHANISM (see Section 3.2.5.5).
3. Remove the MOTOR, CR from the FRAME, MAIN, BASE (see Section 3.2.5. 1).
4. Remove the two CBS(C)(P) (M3 X 10) screws that hold the FRAME, MAIN, RIGHT to the FRAME, MAIN,
BASE. Remove the FRAME, MAIN, RIGHT from the FRAME, MAIN, BASE.
5. Remove the following items from the FRAME, MAIN, RIGHT in the specified order: MOTOR, PF (see
Section 3.2.5.2), CAM, CLUTCH, TRACTOR, COMBINATION GEAR, 8.5,30, SPUR
WASHER, COMPRESSION SPRING 200, and SPUR GEAR, 16.
CBS(C)(P)
When installing the PLAIN WASHER, insert it from the front in the direction indicated by the mark.
I
(M3X 10) Screws ~
COMBINATION GEAR, 8.5, "30 / \ ([ [(~)~
Figure 3-17. Disassembling the FRAME, MAIN, RIGHT
Point to Note for Assembly
Figure 3-18. Direction for Inserting the PLAIN WASHER
FRAME, MAIN, RIGHT
CAM, CLUTCH, TRACTOR ' ~
PLAIN ~ASHER
Mark Side
3-14
GEAR, PLAIN
G, 200
, PF
I