Epson LG1-1070 Service Manual page 110

REV.-A
Ref. No.
1 1/4 of the perimeter of the top edge of the gear (8.5 mm, 30 mm)
2 1/3 of the perimeter of the top edge of the gear (40 mm)
3 1/3 of the perimeter of the top edge of the platen gear
4 Portion of carriage
5 Oil pad
6
Portion of platen shaft that contacts ground spring
7 Gear (40 mm) shaft
8 Gear (8.5, 30 mm) shaft
Ribbon-feed gear shafts
9
10 Gear (1 1.5 mm) shaft
Portion of paper guide that contacts gear (18 mm)
11
Portion of paper guide that contacts sub paper guide
12
13 Portion of release shaft that contacts paper guide
Portion of paper tension roller shaft that contacts paper tension frame
14
15 Portion of tractor shaft that contacts tractor frame (left)
16 Tractor clutch cam
NOTE: Lubrication must be applied during the reassembly process.
Table 6-3. Adhesive Application Point (Refer to Figure 6-l.)
Table 6-2. Lubrication Points (Refer to Figure 6-2)
that contacts base frame
Adhesive Application Point
Portion
where timing belt engages the
carriage
Figure 6-1. Correct Adhesive Application
Lubrication Points
6-2
No. of Points
1
Lubricant
G-26
G-26
G-26
G-26
o-2
G-20
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26