Setting Time And Date / Auto Clock - Sanyo HV-DX3E Instruction Manual

Setting time and date
Setting time and date
Press [VCR] button on the remote control to change into VCR Mode and follow the procedure
below.
Call the player's "SETUP",
1
choose "VCR SETUP", then "CLOCK SET".
Move to the position you want to change and type in the
2
new values.
Wait a few seconds after typing a one-digit number.
Store with [OK] button and exit with [SETUP] button.
Auto clock
Setting Auto clock
Auto Clock is only available for models with the VPS/PDC function (see page 27).
Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will
automatically use this time and date during the initial setting up procedure during normal use, and every
time you switch the video off at the mains. If you find that this time and date is incorrect you can remove
this feature by following the steps below changing it to OFF mode, you will then have to manually set the
time and date, see above.
VCR SETUP
CLOCK SET
RF OUTPUT SET
16:9 SET
OSD ON/OFF
AUTO CLOCK
PR+/-:SELECT
OK:CONFIRM SETUP:END
AUTO CLOCK
ON
OFF
PR+/-:SELECT
OK:CONFIRM SETUP:END
CLOCK SET
TIME - - : - -
DATE - - / - - /- - - -
0-9:SETUP (HOUR)
/ :CORRECT SETUP:END
CLOCK SET
TIME 06:05
DATE 08/08/2004(SUN)
0-9:SETUP (HOUR)
/ :CORRECT
OK:CONFIRM SETUP:END
19