Instructions For The Fr-Pu07Bb (Battery Mode) - Mitsubishi Electric FR-PU07 Instruction Manual

1.4.2

Instructions for the FR-PU07BB (battery mode)

(1) Functions available when using in the battery mode
Parameter
· Parameter read
change · Parameter write
· For monitor, only frequency setting monitor is available
· PU Operation (Only switching between PU/PU Jog
modes is available, not operational)
· Parameter (list, initial value, changed value, read)
· Parameter clear
Functions of
· Read/clear of the faults history
the function
· Inverter reset
menu
· Troubleshooting
· Read of software version
· Output terminal monitor
· Frequency direct setting
· Copy/verification function
(2) FM/AM calibration parameter (Pr.900, Pr.901) cannot be set (calibrated).
(3) For following calibration parameters, only the adjusting method without application of analog voltage
(current) is available.
FR-A700
Pr. 902 to Pr. 905, Pr. 917 to Pr.
920, Pr. 932, Pr. 933
(4) Operation by the FR-E700 series operation panel is invalid.
Only PRM LED of the operation panel lit at this time.
(5) Do not use the FR Configurator. FR Configurator may not function properly.
Connection and Removal of FR-PU07BB
Description
FR-F700
Pr. 902 to Pr. 905
Remarks
· Parameter read/write for plug-in option can be
done in battery mode independently of whether
the plug-in option is mounted or not.
· Monitor value other than frequency setting
monitor is always "0".
· The ON/OFF status of the input signal for the
terminal assignment monitor cannot be
displayed.
· Option fitting status monitor cannot be
displayed.
FR-E700
Pr. 902 to Pr. 905, Pr. 922, Pr. 923
17