Installation Instructions - Garmin Gpsmap 196 Quick Start Manual

Quick Start
Yoke Mount

Installation Instructions

Allen Wrench
(to replace the standard
long clamp adjustment Adjustment Knob
knob)
installed on assembly)
Fully Assembled Yoke Mount
6
Yoke Mount Installation Instructions
The universal yoke mount package includes a pre-assembled yoke mount (assembled with the
long clamp adjustment knob), a short clamp adjustment knob (provided as an alternative to the long
clamp adjustment knob) and an Allen wrench. Please verify that all items are included and contact your
Garmin dealer, should anything be missing.
The short clamp adjustment knob and the Allen wrench allow you to replace the standard long
clamp ad justment knob, which is meant for use on larger yoke control shafts or center column arms.
See page 7 for instructions.
The universal yoke mount is designed to fi t the majority of conventional aircraft yokes, as well as
center column controls on Bonanzas, Barons and other Beech aircraft. Please, note that the yoke mount
package is confi gured for conventional aircraft yokes. If you have a center column control (Beech
models), you should remove the clamp assembly from the yoke mount, rotate it 90° so that the open
end of the clamp faces forward and reattach it to the yoke mount.
To reconfi gure the yoke mount for use on various center column aircraft:
1. Loosen and remove the pivot knob, spacer and rubber washer.
2. Rotate the clamp assembly 90° so that the clamp opening faces forward.
3. Secure the clamp assembly to the yoke mount using the pivot knob, spacer and rubber washer (adjust
Short Clamp
(long knob shown
the clamp to the desired angle BEFORE fully tightening the pivot knob).
Rubber Washer
Clamp
Assembly
Yoke Mount in Conventional Con fi g ura tion
Pivot Knob
Spacer
Yoke Mount in Forward-facing
(Beech) Confi guration