Garmin Gpsmap 196 Quick Start Manual page 10

Quick Start
Vehicle Dash Mount Instructions
The mounting bracket allows attachment of the GPSMAP 196
to the mounting base.
Protruding tab
Two short tabs
Tab Locations on the Mounting Bracket
10
dust and dash protectant prior to each placement. This adhesive also provides maximum support if
spread to conform to the footprint of the mounting base.
To install the mounting bracket on the GPSMAP 196:
Single long tab
Large, curved tab
Allow the permanent type adhesive 24 hours to form an effective bond before using the
dash mount. Use of permanent adhesive may cause residual adhesive to remain on the
vehicle dash when the base is removed. To remove adhesive, use rubbing alcohol.
Repositionable adhesive performs best if the area of the dash where it is placed is fully cleaned of
Replacement adhesive disks of both types are available from any Garmin dealer.
1. Align the single long tab located on the right-hand side of the bracket (front view) with the matching
groove located on the right-hand side of the unit (i.e., front view, antenna side), at the back (see
illustrations below).
2. Push the bracket toward the unit so that both the large, curved tab at the bottom center of the
bracket and the two short tabs located on left-hand side of the bracket (front view) snap into the
grooves located at the back and bottom of the unit and on the left-hand side of the unit (front view),
respectively (see illustrations below).
Long groove
Large, curved groove
Groove Locations on the GPSMAP 196
1
Align long tab with
corresponding groove
on unit
Two short
grooves
2
Push bracket toward unit
and snap into place
Installing the Mounting Bracket