Garmin Gpsmap 196 Quick Start Manual page 8

Quick Start
Yoke Mount
Installation Instructions
Yoke Mount Snap-in Bracket
Unit Installed on Yoke Mount
8
controls and place the GPSMAP 196 into the mount.
Long tab
Two short tabs
Protruding tab
Once the yoke mount is confi gured to your application, attach the yoke mount to the aircraft
To attach the yoke mount to the aircraft yoke shaft or control arm:
1. Open the clamp by turning the clamp adjustment knob counterclockwise. Open the clamp until it can
easily be slipped over the yoke shaft or control arm at the desired location.
2. Place the open clamp over the yoke shaft or control arm and turn the clamp adjustment knob
clockwise to tighten the clamp (if the standard clamp adjustment knob is too long, see page 7 for
instructions on replacing it with the short clamp adjustment knob).
3. Loosen the pivot knob and adjust the viewing angle, as desired (in some instances, the pivot knob
may need to be loosened prior to step #2 so as to allow the mount to set down over the yoke).
4. Tighten the pivot knob and verify that the clamp adjustment knob is also securely tightened.
To place the GPSMAP 196 in the yoke mount:
1. Locate the three lock ing tabs molded into the snap-in brack et and the corresponding grooves on the
GPSMAP 196 unit (see illustration at left).
2. Align the long tab located on the right-hand side of the snap-in bracket with the corresponding
groove on the unit.
3. Gently push the unit into the bracket until the two short tabs located on the left-hand side of the
bracket snap into their corresponding grooves on the unit.
To remove the GPSMAP 196 from the yoke mount:
1. While holding the unit, lift and pull the protruding tab on the left-hand side of the bracket out and
away from the unit so as to dislodge the two short tabs from their corresponding grooves on the
bracket.
2. Pull the unit out and away from the bracket.