Quick Adjustment
1
(Additional Functions) ➞ [Adjustment/Cleaning] ➞
Press
[Auto Gradation Adjustment].
2
Press [Quick Adjust].
3
Press [Start].
Full Adjustment
IMPORTANT
•
Make sure that you place the test prints properly. Accurate recalibrations of the gradation,
density, and color settings of the machine cannot be made if the test prints are not
scanned correctly.
•
Three test prints are output by the machine during this adjustment. Make sure that a
sufficient supply of 11" x 17" or LTR paper is loaded into the machine before starting this
procedure.
NOTE
Test prints are not counted as part of the copy or print total page counts.
1
(Additional Functions) ➞ [Adjustment/Cleaning] ➞
Press
[Auto Gradation Adjustment].
2
Press [Full Adjust].
3
Press [Test Print 1].
NOTE
If the paper which is appropriate for the test print is not loaded in a paper source, a
message asking you to load the appropriate paper appear. In this case, load the
appropriate paper in a paper source.
4
Place the first test print on the platen glass.
Place the test print face down on the platen glass, with the black bands along the
top left back edge of the platen glass by the arrow.
Adjusting the Machine
4
4-69