Update; Info - Digimerge DH200+R Series Instruction Manual

UPDATE

Use the Update menu to upgrade system
firmware.
NOTE: The system supports most major
brands of USB flash drives with a capacity
of 10 MB ~ 16 GB.
To upgrade firmware:
1. Download the latest firmware update from
the Digimerge website.
2. Copy the firmware to a blank USB flash
drive.
NOTE: Do not have any folders on the USB
flash drive—just the firmware file.
3. Connect the USB flash drive to the USB
port on the front or back panel.
4. Stop all recording on the system.
You must stop all recording in order
NOTE:
to perform the upgrade.
5. Open the Main Menu and select SYSTEM.
6. Under the UPDATE tab, select UPDATE.
7. Select START and press the ENTER
button. Firmware upgrade begins.
remove the USB flash drive until the
upgrade process is complete.
any buttons or power off the system during
the upgrade process.
When upgrade is finished, click the REBOOT
button in the prompt window to restart the
system.

INFO

View important system information:
• S/W VERSION: The current system
• DOMAIN NAME: Your Digimerge DDNS
• MAC: The MAC address of the DVR on your
• LANGUAGE: The current system language.
• NETWORK: The IP address of the system.
)
(
• RECORD DISK: HDD, size and space
Do not
• DISK SUMMARY: The status of the HDDs,
Do not
press
• SYSTEM HEALTH: Indicates system
• USB (FRONT): The status of the USB port
• USB (REAR): The status of the USB port on
firmware version.
domain name.
network.
remaining.
and what state they are in.
• STREAM: the hard drive is in recording
mode.
temperature and voltage.
on the front panel.
the rear panel.
Using the Main Menu
51