Changing The Siren-On Time; Setting Up The Tilt Sensor; Arming The System; Disarming The System - Bailey Motorhomes Owner's Manual

4.22.7 Changing the Siren-on Time

1. Press "F", press "3".
2. Enter your personal code,
3. Enter the preferred time as 3 digits, i.e. 2 minutes is entered 200, (please note the maximum time
allowed is 4 minutes, i.e. 400)
4. Press "F".
5. This operation can be cancelled at any time before step 3 by pressing "C".

4.22.8 Setting up the Tilt Sensor

The tilt sensor is not adjustable and requires the caravan to be reasonably level. If the Tilt Sensor is
active, one of the Tilt Sensor Indicators will illuminate on the keypad. Adjust the level of the van until the
light goes off.

4.22.9 Arming the System

If you are in the PIR's line of sight, it is possible that when arming the system, any movement detected
by the PIR will deselect the PIR channel. To avoid deselecting the PIR accidentally please ensure that
you remain perfectly still when arming the system. This is very important when the keypad is sited
within the PIR coverage area.
1. Enter the personal code, the indicators for all available sensors will light (If a sensor indicator fails to
light, see "TROUBLESHOOTING").
2. To Disable any sensors not required, press the relevant key, i.e. 1 for PIR, 2 for tilt, 3 for tow sensor.
Repeated pressing will select (light comes on) and disable (light goes off) the relevant sensor.
3. Press "F". The exit delay will begin, 1 pulse per second.
4. Two short bursts on the siren will be heard at the end of the exit delay. This confirms the system is
armed.
5. This operation can be cancelled at any time before step 4 by pressing "C".

4.22.10 Disarming the System

1. Enter your personal code. (This is the only way to disarm the system)
2. If the system has been inactive all indicators will flash twice on the keypad.
3. If a sensor has been activated then the corresponding light on the keypad will flash five times.
However if the system had been continuously active for 20 minutes or more (and subsequently
reset) there will be a random flashing of indicators preceding the display of the sensor(s) responsible.
▲ When the siren is active there is no limit on key entries When the siren is inactive a
maximum of 16 key entries are allowed. If 16 key entries are exceeded then the system
will not accept any more entries until the siren is activated.

4.22.11 Memory Recall

This enables the user to tell if any sensors were active during the previous armed state.
1. Press "F", press "5"; watch the indicators.
Caravan Equipment
4
4-43