Table of Contents
Advertisement
4
Caravan Equipment
4.21.1 Retensioning
REMIflair blinds are delivered with the correct
amount of tension in the spring. However, it may
be necessary in the future to adjust the spring.
On the left hand side of the cassette you will find
two tensioning screws. The top one is for the fly
screen and the lower screw is for the sun screen.
Rotate clockwise 1 or 2 turns until the correct
tension is reached. The blinds should rewind
without stopping or in a sluggish manner. Take
care no to over tighten the spring.
4.21.1 Cleaning
Clean the cassette, side tracks and fabrics with
warm water and a mild detergent.
of cleaners with solvents or abrasives.
▲ It is not recommended to leave the
blinds pulled down for long periods
of time. This can result in material
distortion and spring fatigue.
4.22
IDM3 / IDM2000 CARAVAN
ALARM
4.22.1 Factory Settings
Entry Delay - 0:00 (0 secs)
Exit Delay - 0:20 (20secs)
Siren On Time - 1:00 (1 minute)
Manufacturers Personal Code - 1234
Operation
4.22.2 Alarm Keypad - IDM2000
4-42
4.22.3 Alarm Keypad - IDM3
4.22.4 Changing the Personal Code
1. Press "F", press "1".
Avoid the use
2. Enter the current code. (1234 if new)
3. Enter desired 4 digit code.
4. Press "F".
5. This operation can be cancelled at any time
before step 4 by pressing "C".
4.22.5 Changing the Entry Delay Time
1. Press "F", press "0"
2. Enter your personal code.
3. Enter the new entry delay as 3 digits. i.e. 10
seconds is entered 010,
4. Press "F".
5. This operation can be cancelled at any time
before step 3 by pressing "C".
4.22.6 Changing the Exit Delay Time
1. Press "F", press "2".
2. Enter your personal code,
3. Enter the new exit delay as 3 digits. i.e. 20
seconds is entered 020, 1 minute is 100. (Please
note the maximum time allowed is
400).
4. Press "F".
5. This operation can be cancelled at any time
before step 3 by pressing "C".
▲ The Entry Delay Time must be as
short as possible to prevent
compromising security.
4 minutes i.e.
Advertisement
Table of Contents
Troubleshooting
