Display And Debug Snmp - 3Com 7700 Configuration Manual

26 C 11: S M
HAPTER YSTEM
Display and Debug
SNMP
ANAGEMENT
Create/Update View Information or Deleting a View
You can use the following commands to create, update the information of views
or delete a view.
Perform the following configuration in system view.
Table 49 Create/Update View Information or Deleting a View
Operation
Create/Update view information
Delete a view
Set the Size of SNMP Packet Sent/Received by an Agent
You can use the following commands to set the size of SNMP packet sent/received
by an agent.
Perform the following configuration in system view.
Table 50 Set the Size of SNMP Packet Sent/Received by an Agent
Operation
Set the size of SNMP packet
sent/received by an agent
Restore the default size of SNMP
packet sent/received by an agent
The agent can receive/send the SNMP packets of the sizes ranging from 484 to
17940, measured in bytes. By default, the size of SNMP packet is 1500 bytes.
Disable the SNMP Agent
To disable SNMP Agent, please Perform the following configuration in system
view.
Table 51 Disable SNMP Agent
Operation
Disable snmp agent
If user disable NMP Agent, it will be enabled whatever snmp-agent command is
configured thereafter.
After the above configuration, execute display command to view the SNMP
configuration, and to verify the effect of the configuration. Execute debugging
command in user view to debug SNMP configuration.
Table 52 Display and Debug SNMP
Operation
Display the statistics information
about SNMP packets
Display the engine ID of the active
device
Command
snmp-agent mib-view { included | excluded }
view-name oid-tree
undo snmp-agent mib-view view-name
Command
snmp-agent packet max-size byte-count
undo snmp-agent packet max-size
Command
undo snmp-agent
Command
display snmp-agent statisitcs
display snmp-agent { local-engineid | remote-engineid }