3Com 7700 Configuration Manual page 26

18 C 1: S A
HAPTER YSTEM CCESS
Perform the following configuration in system view.
Table 13 Set Command Priority
Operation
Set the command priority in a
specified view.
Restore the default command
level in a specified view.
Configure the Attributes of a Modem
You can use the commands described in Table 14 to configure the attributes of a
modem when logging in to the switch through the modem.
Perform the following configuration in user interface view.
Table 14 Configure Modem
Operation
Set the interval since the system
receives the RING until CD_UP
Restore the default interval since
the system receives the RING until
CD_UP
Configure auto answer
Configure manual answer
Configure to allow call-in
Configure to bar call-in
Configure to permit call-in and
call-out.
Configure to disable call-in and
call-out
Configure Redirection
The send command can be used for sending messages between user
interfaces. See Table 15.
Perform the following configuration in user view.
Table 15 Configure to Send Messages Between User Interfaces
Operation
Configure to send messages
between different user interfaces.
The auto-execute command is used to run a command automatically after
you log in. The command is automatically executed when you log in again. See
Table 16.
This command is usually used to execute the telnet command automatically on
the terminal, which connects the user to a designated device.
Command
command-privilege level level view view command
undo command-privilege view view command
Command
modem timer answer seconds
undo modem timer answer
modem auto-answer
undo modem auto-answer
modem call-in
undo modem call-in
modem both
undo modem both
Command
send { all | number | type number }