3Com 7700 Configuration Manual page 239

You can use the following commands to set the community name.
Perform the following configuration in system view.
Table 39 Set Community Name
Operation
Set the community name and the
access authority
Remove the community name and
the access authority
Set the Method of Identifying and Contacting the Administrator
The sysContact is a management viable of the system group in MIB II. The content
is the method of identifying and contacting the related personnel of the managed
device.
You can use the following commands to set the method of identifying and
contacting the administrators.
Perform the following configuration in system view.
Table 40 Set the Method of Identifying and Contacting the Administrator
Operation
Set the method of identifying and
contacting the administrator
Restore the default method of
identifying and contacting the
administrator
Enable/Disable snmp Agent to Send Trap
The managed device transmits a trap without request to the NMS to report critical
and urgent events (such as restart).
You can use the following commands to enable or disable the managed device to
transmit trap message.
Perform the following configuration in system view.
Table 41 Enable/Disable SNMP Agent to Send Trap
Operation
Enable to send trap
Disable to send trap
Set the Destination Address of Trap
You can use the following commands to set or delete the destination address of
the trap.
Command
snmp-agent community { read | write }
community-name [ [ mib-view view-name ] [ acl acl-list ]
]
undo snmp-agent community community-name
Command
snmp-agent sys-info contact sysContact
undo snmp-agent sys-info contact
Command
snmp-agent trap enable [ standard [ authentication ]
[ coldstart ] [ linkdown ] [ linkup ] [ warmstart ] ]
undo snmp-agent trap enable [ standard [
authentication ] [ linkdown ] [ linkup ] [ coldstart ] [
warmstart ] ]
SNMP 23