Ethernet Link Aggregation Troubleshooting - 3Com 7700 Configuration Manual

36 C 2: P C
HAPTER ORT ONFIGURATION
Ethernet Link
Aggregation
Troubleshooting
Mode: both
When configuring link aggregation, you might see a message that the
configuration has failed. To address this situation:
Check the input parameter and see whether the starting number of Ethernet
■
port is smaller than the end number. If yes, take the next step.
Check whether the Ethernet ports that are in the configured range belong to
■
any other existing link aggregations. If not, take the next step.
Check whether the ports to be aggregated operate in the same speed and full
■
duplex mode. If yes, take the next step.
If correct, configure the link aggregation again.
■