Set Snmpv3 - Xerox D95 Supplementary Manual

Set SNMPv3

1. Click [Connectivity] on the [Properties] screen.
2. Click [Protocols].
3. Click [SNMP Configuration].
4. Check the [Enable SNMPv3 Protocol] box.
5. Uncheck the [Enable SNMPv1/v2c Protocols] box.
6. Click [Apply].
7. Click [Edit SNMPv3 Properties] and check [Account Enabled] for [Administrator Account].
8. Enter a new Authentication Password (minimum 8 characters).
9. Enter the new Authentication Password again to confirm it.
10. Enter a new Privacy Password (minimum 8 characters).
11. Enter the new Privacy Password again to confirm it.
12. Check [Account Enabled] for [Print Drivers/Remote Clients Account].
13. Click [Apply].
Note: Be sure to change Authentication Password and Privacy Password from the default
password.
In using SNMPv3, use the IPSec protocol simultaneously. You need to set the IP address of the
client for SNMPv3 according to the procedures in "Set IPSec Address" and enter the IP Address
in the [Specify Destination IPv4/IPv6 Address] box.
Since the machine cannot communicate by SNMPv1/v2, you need to uncheck [SNMP status
Enabled] for the port setting on the client's printer driver.
®
22 Xerox D95/D110/D125 Copier/Printer Security Function Supplementary Guide