Self Testing; Set Self Test - Xerox D95 Supplementary Manual

5

Self Testing

This section describes the Self Test function and its setting procedure from the Control Panel.
The machine can execute a Self Test function to verify the integrity of executable code and
setting data.
The machine verifies the area of NVRAM and SEEPROM including setting data at initiation,
and displays an error on the control panel at error occurrence.
Also, when Self Test function is set at initiation, the machine calculates the checksum of
Controller ROM to confirm if it matches the specified value, and displays an error on the
control panel at error occurrence.

Set Self Test

1. Select [System Settings] on the [Tools] screen.
2. Select [Common Service Settings].
3. Select [Maintenance].
4. Select [Power on Self Test].
5. Select [On].
6. Select [Save].
7. To exit the [Maintenance] screen, select [Close].
8. To exit the [Tools] screen, select [Close] in the upper right corner of the screen.
®
Xerox D95/D110/D125 Copier/Printer Security Function Supplementary Guide 27