Sherwood R-904 Operating Instructions Manual page 26

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 26
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes. (For details, refer to "When selecting the CHANNEL LEVEL" on page 39.)
1.
Select the desired channel.
2.
Adjust the level of the selected channel as desired.
3.
Repeat the above steps 1 and 2 to adjust each channel level.
• Each time this button is pressed, the channel is selected as
follows:
→ → C →
L R
Front Center Front
Left Right
SW
Subwoofer
( ) : Possible only when the surround back speaker is set to
2ch ("x2") or 1ch ("x1")
• When the channel level disappears, press this button
again.
• Depending on the speaker settings ("NO"), etc., some
channels cannot be selected.
• The channel levels can be adjusted within the range of
-15 ~ +15 dB.
■Note:
• When selecting the VuNow as an input source, you
cannot adjust the channel levels.
26
→ SR → (SBR → SBL)
Surround Surr. Back Surr. Back
Right Right Left
← ←
SL
Surround Left