Setting The Speaker Setup - Sherwood R-904 Operating Instructions Manual

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 37

SETTING THE SPEAkER SETUP

• After you have installed this receiver and connected all the components, you should adjust the speaker settings for the
optimum sound acoustic according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the
speaker settings, too.
• When performing the Room EQ setup procedure, you need not perform the SPEAKER CONFIGURATION, the CHANNEL
LEVEL and the SPEAKER DISTANCE procedures. (For details, refer to "SETTING THE ROOM EQ" on page 36.)
• SPK CFG (SPEAKER CONFIGURATION) : To adjust the speakers depending on whether they are connected or not.
• X.OVER (CROSSOVER FREQUENCY) : To select the desired crossover frequency.
• CH (CHANNEL) LEVEL : To adjust each channel level with the test tone.
• DISTANCE (SPEAKER DISTANCE) : To select the distance between the listening position and each speaker to set the delay
SPK CFG F : LARGE / SMALL
C : LARGE / SMALL / NO
S : LARGE / SMALL / NO
SB : LX2 / LX1 / SX2 / SX1 / NO
SW : YES / PLUS / NO
X.OVER X.OVER : 50 / 80 / 100 / 150 / 200
CH LEVEL T. TONE : M / A
DISTANCE L : 3.0 M / 0.1 ~ 9.0
C : 3.0 M / 0.1 ~ 9.0
R : 3.0 M / 0.1 ~ 9.0
SR : 3.0 M / 0.1 ~ 9.0
SBR : 3.0 M / 0.1 ~ 9.0
SBL : 3.0 M / 0.1 ~ 9.0
SL : 3.0 M / 0.1 ~ 9.0
SW : 3.0 M / 0.1 ~ 9.0
time automatically for optimum surround playback.
37
L : 0 dB / -15 ~ +15
C : 0 dB / -15 ~ +15
R : 0 dB / -15 ~ +15
SR : 0 dB / -15 ~ +15
SBR : 0 dB / -15 ~ +15
SBL : 0 dB / -15 ~ +15
SL : 0 dB / -15 ~ +15
SW : 0 dB / -15 ~ +15