Setting The System - Sherwood R-904 Operating Instructions Manual

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 35

SETTING THE SYSTEm

• AMP (AMP ASSIGN) : To assign the surround back channels' power amplifier correctly depending on how to use the speakers.
• TONE : To adjust the tone (bass and treble) as desired.
1.
Press the CURSOR UP/DOWN buttons to select the desired item.
2.
Press the CURSOR LEFT/RIGHT buttons to set the selected item as desired.
■When selecting the AmP ASSIGN
• The surround back channels' power amplifier can drive the surround back speakers or the ROOM 2 speakers. Depending on
how to use the speakers, you should assign the power amplifier correctly. (For details, refer to "CONNECTING SPEAKERS" on
page 7 and "CONNECTING ROOM2 SPEAKERS" on page 8.)
BACK (SURROUND BACK) : To drive the surround back speakers when connecting the SURROUND BACK/ROOM2 channels
↕
R2 (ROOM2) : To drive the ROOM2 speakers when connecting the SURROUND BACK/ROOM2 channels to them.
■When selecting the TONE
OFF : To listen to a program source without the tone effect. ("DIR" lights up.)
↕
ON : To adjust the tone for your taste. ("DIR" goes off.)
◆When the TONE CONTROL is set to ON to adjust the tone (bass and treble)
①. Press the ENTER button to enter the tone adjustment mode.
• Then "TRE ~" will be displayed.
②. Press the CURSOR UP/DOWN buttons to select the desired tone mode.
③. Press the CURSOR LEFT/RIGHT buttons to adjust the selected tone as desired.
• The tone level can be adjusted within the range of -10 ~ +10 dB.
• In general, we recommend the bass and treble to be adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your speakers.
• To complete tone adjustment, repeat the above steps ② and ③.
AMP : BACK / R2
TONE : OFF / ON
to them.
TRE : 0 / -10 ~ +10
BASS : 0 / -10 ~ +10
35