Create New Iax Extension; Table 32: Iax Extension Configuration Parameters - Grandstream Networks UCM6102 User Manual

Skip Trunk Auth
Dial Trunk Password
Strategy
Codec Preference
Specific Time
Time Condition

CREATE NEW IAX EXTENSION

To manually create new IAX user, go to Web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New User"->"Create New IAX Extension" and a new dialog window will show for users to fill in
the extension information. The configuration parameters are as follows.
General
Extension
CallerID Number
Permission
Firmware Version 1.0.7.11
Note:
If enabled, Fax Pass-through cannot be used.
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Configure personal password when making outbound calls via trunk.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.

A Specific IP Address
Only the device on the specific IP address can register this
extension.
The default setting is "Allow All".
Select audio and video codec for the extension. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729, G.723,
ILBC, ADPCM, H.264, H.263 and H.263p.
Click on add Time Condition to configure specific time for this extension.

Table 32: IAX Extension Configuration Parameters

The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
UCM6100 Series IP PBX User Manual Page 89 of 233