Create New Iax Extension; Table 18: Iax Extension Configuration Parameters - Grandstream Networks UCM6510 User Manual

Strategy
Skip Trunk Auth
Codec Preference

CREATE NEW IAX EXTENSION

To manually create new IAX user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New User"->"Create New IAX Extension" and a new dialog window will show for users to fill in the
extension information. The configuration parameters are as follows.
General
Extension
CallerID Number
Permission
Firmware Version 1.0.0.5
Note:
If enabled, Fax Pass-through cannot be used.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.

A Specific IP Address
Only the device on the specific IP address can register this
extension.
The default setting is "Allow All".
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729,
G.723, ILBC, ADPCM, H.264, H.263 and H.263p.

Table 18: IAX Extension Configuration Parameters

The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
UCM6510 IP PBX User Manual Page 54 of 192