Removing The Seat; Cleaning The Air Filter - KTM 65 SX 2003 Owner's Manual

1
2
26
4
3
4
5
A

Removing the seat

By using the quick-release mechanism
using tools. Turn the quick-release mechanism about 180° counter
clockwise and lift up the rear of the seat. Pull the seat backwards and
unhook it from the fixing screw
To mount the seat, position seat on the fixing screw
forward and fix with the quick release.
1

Cleaning the air filter*

To do this, remove the seat and the air filter cover from the air filter box.
Unclap the filter holder
carrier
D
FOAM
FILTER MAINTENANCE
Thoroughly wash the foam filter in special cleaning fluid and allow to dry
well. Only press out the filter, do not wring out under any circumstances.
Oil the dry foam filter with a high grade filter oil. Also clean the air filter box.
Check carburetor collar
3
Mount the air filter
filter to improve the seal. Mount the air filter and the filter support in the
filter box. Make sure they are centered, and lock into place with the filter
holder
3
, swing back and remove air filter
5
from the filter box.
CAUTION
!
O NOT CLEAN FOAM FILTER WITH FUEL OR PETROLEUM SINCE THESE DAMAGE THE
. KTM
RECOMMENDS THE PRODUCTS OF THE COMPANY
.
A
for damage and that it is fitted correctly.
4
on the filter support
3 .
1
, the seat can be removed without
2 .
2
and tank, push
TWIN AIR
5
. Grease the front side of the
4
plus filter
!
FOR AIR