KTM 65 SX 2003 Owner's Manual page 16

VITAL CHECKS AND CARE PROCEDURES TO BE CONDUCTED BY THE OWNER OR THE MECHANIC
Check transmission oil level
Check coolant level
Check brake fluid level
Check brake pads for wear
Check brake performance
Lubricate and adjust actuating ga scable and nipples
Remove and clean dust sleeves of telescopic fork at regular intervals
Bleed fork legs regularly
Clean and lubricate chain, check tension and readjust it if necessary
Clean air filter and filter box
Check tire inflation pressure and wear
Check fuel line for leaks
Drain and clean float chamber
Verify smooth operation of all controls
Treat exposed metal components (except for the brake and exhaust systems)
with wax-based anti-corrosion agents
Treat all electric plug-in connections with contact spray
Check all screws, nuts, and hose clamps for their tight fit at regular intervals
R
ECOMMENDED INSPECTION OF THE
(
ADDITIONAL ORDER FOR THE
Check the reed-type intake valve for wear
Check the clutch shoes for wear
Check the length of the clutch springs
Check the cylinder and piston for wear
Check the eccentricity of the crankshaft journal
Check the radial clearance of the conrod bearings
Check the radial clearance of the piston pin main bearing
Check the crankshaft main bearing for wear
Replace the crankshaft bearings and conrod bearings
Check the entire transmission including roller and bearings for wear
NOTE: I
F THE INSPECTION ESTABLISHES THAT PERMISSIBLE TOLERANCES ARE EXCEEDED
65 SX
ENGINE BY YOUR
KTM'
S WORKSHOP
30 45
hours hours
,
THE RESPECTIVE COMPONENTS MUST BE REPLACED
as of 03.2002
KTM
WORKSHOP
)
60
90 120
hours
hours hours
.
15
135
hours