Checking Of Brake Fluid Level - Front Brake; Refilling The Front Brake Fluid Reservoir; Checking The Front Brake Pads - KTM 65 SX 2003 Owner's Manual

Ktm motorcycle
Table of Contents

Advertisement

1
min.
1 mm
Checking brake fluid level - front brake
The brake fluid reservoir is combined with the hand brake cylinder on the
handlebar and provided with an inspection glass. When the brake fluid
reservoir is in a horizontal position, the brake fluid level should not drop
below the "MIN" mark on the inspection glass.
D
ROPPING OF THE BRAKE FLUID LEVEL BELOW THE
THE BRAKE SYSTEM OR TOTALLY WORN BRAKE PADS
KTM
LICENSED
Refilling front brake fluid reservoir *
1
When the brake fluid falls to the middle of the inspection glass, new brake
fluid has to be added.
Loosen screws
2
Place hand brake cylinder in a horizontal position and fill the brake fluid
reservoir to 5 mm (0.2 in) below the rim with clean brake fluid DOT 5.1
(Shell Advance Brake DOT 5.1). Replace membrane and lid, tighten screws.
Rinse off spilled or overflowing brake fluid with water.
3
– N
EVER USE
. S
COLOR
– S
TORE BRAKE FLUID OUT OF REACH OF CHILDREN
– B
RAKE FLUID CAN CAUSE SKIN IRRITATION
YOU GET BRAKE FLUID IN YOUR EYES
DOCTOR
– D
'
ON
T LET BRAKE FLUID GET IN CONTACT WITH PAINT
5 mm
REMOVER
– U
SE ONLY CLEAN BRAKE FLUID TAKEN FROM A TIGHTLY SEALED CONTAINER

Checking the front brake pads

The brake pads can be inspected from below. The linings nust be at least
1 mm (0.04 in) thick.
A
T THEIR MOST WORN POINT BRAKE PAD LININGS SHOULD NOT BE THINNER THAN
OTHERWISE THEY COULD LEAD TO BRAKE FAILURE
OFF HAVING YOUR BRAKE PADS CHANGED
I
F THE BRAKE PADS ARE REPLACED TOO LATE SO THAT THE LINING IS PARTLY OR ENTIRE
,
LY WORN
,
DISC
THEREBY IMPARING THE BRAKING EFFECT AND DESTROYING THE BRAKE DISC
WARNING
.
DEALER IMMEDIATELY
1
2
and remove lid
and membrane
WARNING
DOT 5
! I
BRAKE FLUID
T IS BASED ON SILICONE OIL AND OF A PURPLE
EALS AND BRAKE HOSES MUST BE ESPECIALLY ADAPTED TO IT
. A
,
RINSE WITH PLENTY OF WATER AND CONSULT A
!
CAUTION
!
.
WARNING
.
CAUTION
!
THE STEEL COMPONENTS OF THE BRAKE PAD WILL RUB AGAINST THE BRAKE
"MIN"
MARK INDICATES LEAKS IN
. I
,
N THIS CASE
CONTACT A
3
.
.
.
VOID CONTACT WITH SKIN AND EYES
!
,
IT IS AN EFFECTIVE PAINT
.
1
. F
'
OR YOUR OWN SAFETY DON
!
.
. I
21
F
,
MM
T PUT
-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents