O ther P roblems
H as ink run out?
The Media H eating Sy stem Doesn't W arm Up
Is media loaded?
Is the tem p erature o f the
room too low?
Cannot Cut O f f the Media
Is the sep arating k nif e in-
stalled?
6
Is the cut rail installed?
18 2
1 2 3 4
When the screen shown in the gure is displayed, output data cannot be
accepted. If the screen shown in the gure is displayed during printing,
the behavior of the machine depends on the [EMPTY MODE] setting.
• W h e n " S TO P " i s s e
l e c t e d : Th e p r i n t i n g o p e r a t i o n i s p a u s e
• W h e n
" C O N T. " i s s e l e c t e d : A
continues unti the achine has finished printing the data it has accepted
I n t h i s c a s e , i t i s a l s o p o s s i b l e t o p r e s s [ P A U S E ] a n d p a u s e p r i n t i n g .
In both cases, the error can be resolved by replacing the ink pouch
with a new one. If there is data that has not yet been output
remaining in the machine, output resumes. If there is unsent
data in the computer, output resumes when the data is resent.
" P . 66 " I n k P o u c h
Re p l a c e
m e n t "
" P . 15 4 " D e t e r m i n i n g W h a t H a p p e n s W h e n I n k Ru n s O u t "
The media heating system does not warm up to the set tempera-
ture when [SETUP] is o (by default). Load the media and wait for
the machine to warm up.
" P . 115 " S e t t i n g s f o r t h e M e d i a H e a t i n g S y s t
Use the machine in an environment where the temperature is
20 to 32°C (68 to 90°F).
If the separating knife is not installed, you cannot cut o the media.
" P . 107 " Re p l a c i n g t h e S e p a r a t i n g K n i f e "
If the cut rail is not installed, you cannot cut o the media. If the
cut rail is not installed, remove the left cover, and then install the
cut rail according to the gure shown below. After installing the
cut rail, be sure to attach the left cover.
d .
w a r n i n g
b e e p
s o u n d s , a n d
p r i n t i n g
e m "