Denon DN-D9000 Operating Instructions Manual page 15

Splice
• Use this function to skip a section between A and B points. The A point is the point from which jumping starts,
the B point the point at which jumping ends.
• The A1 and A2 Hot Starts and Stutter functions cannot be used if both Splice points are set in the Splice mode.
w r, t
,
-TRACK HOT START
SAMPLER
RVS SAMP1 SAMP2
FLIP A 3 A 4
t CLR A3 A4 CUE
FLIP A 1 A 2
CLR A1 A2
A3 B
A1 B
TOTAL REMAIN ELAPSED CONT. SINGLE
m s
m s f
MEMO
PROG
CONT./SINGLE TIME MEMO PROGRAM
RELAY TOTAL TIME PRESET RANDOM
CUE
STUTTER PLAY/PAUSE
Splice point setting mode
q Push the SPLICE button for
A/B TRIM
more than 1 sec to enable
setting Splice point using A1,
SPLICE
A2 and B buttons.
1
• The A button illumination flashes when
the Splice mode is set.
• The Splice point setting cannot be set
for the A point at which Hot Start data
is already loaded.
Set splice start point A
w After starting playback, push
A 1
the A1 or A2 button. The
2
corresponding A button lights
up and that point is set as
splice start point A, and B LED
start flashing.
Set splice end point B
e After setting splice start point
B
3
A, push the B button. The B
LED lights up and that point is
set as splice end point B.
Start splice playback
Start playback from any point before point A.
4
When point A is reached, the section from
point A to point B is jumped seamlessly and
playback continues.
e q
-TRACK PLAY -TRACK HOT START
PARAMETERS TRACK
B EXIT/RELOOP RVS
STOP
PUSH
ON/OFF
EXIT/ OPEN/
B CUE FLIP
RELOOP CLOSE
CLR A3 A4 CUE
A 3/4 A/B TRIM
PITCH/KEY PITCH BEND
EXIT/
B FLIP
RELOOP
4 HOT START PITCH/VOL SPLICE CLR A1 A2
RANGE
A4 B A3 B
A2 B A1 B
KEY ADJ. DRAG S.
BRAKE
ECHO
DUMP MEMO
RVS PROG
0%
PLATTER MODE CONT./SINGLE
ALL OFF RELAY
CUE
TAP
AUTO STUTTER
REMOTE CONTROLLER RC-D90
Temporarily turning off the splice playback
r When the corresponding A
button is pushed after setting
splice points A and B, the A
5
button illumination turns off
and the Splice play mode is
temporarily turned off.
• Push the corresponding A button again
to resume splice playback.
Clearing the splice points
t While pressing the FLIP/(CLR) button, push
the corresponding A button to clear splice
points A and B.
FLIP
A 1
6
• When the splice points are cleared, the
A button is set back to the hot start
mode.
SAMPLER
SAMP1 SAMP2 B
A 3 A 4 B
A 1 A 2 B
TOTAL REMAIN ELAPSED CONT. SINGLE KEY AD
m s
m s f
TIME MEMO PROGRAM
TOTAL TIME PRESET RANDOM
PLAY/PAUSE
A 1
ENGLISH
15