Reset; Set Interface Broadcast-Limit - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
46 Confidential and Proprietary Information of ZTE CORPORATION
� The parameter <interface-name> only supports ATM, POS and
E1 interfaces.
�
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to configure the line clock of interface
pos48_6/1 as the clock source of the SMP.
ZXR10(config)#reference clock port pos48_6/1

reset

Use this command to reset the specified serial port board.
Privileged EXEC
reset <board-name>
<board-name>
If this area is configured, it is enabled by default.
It is applied only to the serial port board of ZXR10 GAR, ZXR ZSR.

set interface broadcast-limit

Use this command to set the rate limit (in percent) of broadcast
packets on Ethernet ports in batch.
Global configuration
set interface broadcast-limit <percent-value><port-list>
<percent-value>
<port-list>
The parameter <port-list>describes the port list of the batch
configuration. For example, "fei_1/3-6, gei_2/3" means that the
batch configuration is for ports fei_1/3, fei_1/4, fei_1/5, fei_1/6
and gei_2/3.
This example describes how to set the rate limit to broadcast pack-
ets on ports fei_1/1, fei_1/2 and fei_1/3 to 10.
ZXR10(config)#set interface broadcast-limit 80 fei_1/1-3
Name of the specified serial port board
Rate limit to broadcast packets, ranging
1–100, 100 by default
Port list of the batch configuration