Keepalive; Linecode - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
34 Confidential and Proprietary Information of ZTE CORPORATION
set interface jumbo-frame

keepalive

Use this command to set keepalive value of the interface.
Interface configuration
keepalive [<seconds>]
no keepalive
<seconds>
� When the interface adopts PPP for encapsulation, the router
sends a PPP ECHO request packet in the interval of keepalive.
If no ECHO-REPLY is received after sending five ECHO packets
successively, the interface will be shut down.
� To cancel PPP keepalive, use no keepalive. To restore the
default, use keepalive.
� When the interface adopts frame relay for encapsulation, the
parameter ranges 1–30.
smaller than interval t392 of the frame relay switch.
� This command is valid only when the interface adopts PPP, FR,
HDLC or X25 for encapsulation.
This example describes how to set keepalive of interface Serial_1/1
to 100 seconds.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#keepalive 100

linecode

Use this command to configure the linecode format of interface
CE1 and CT1.
CE1, CT1 controller configuration
linecode {ami | bz8s}
ami
bz8s
The linecode is bz8s by default.
1. This example describes how to set the linecode of interface
CE1.
ZXR10(config)#controller ce1_3/1
Value of keepalive(in second), ranging 1 ~
32767, 10 by default
In this case, <seconds>must be
ami linecode
bz8s linecode