Mtu - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
monitor session <session-number>{desigation | source [dir
ection {both | tx | rx}]}
no monitor session
<session-number>
designation
source
direction
both
tx
rx
The collection direction is dual-direction.
� Each session can be configured with up to eight source ports
and one destination port. Each port can be either the source
or the destination, but not both.
� In configuring the source/destination port with the command,
if the session number does not exist, create a session first,
and then add the source/destination port. In configuring the
destination port, if the session already holds a destination port,
the configuration is invalid.
� If the source/destination ports of each session are on the same
line interface board, the system supports up to eight sessions.
If the source/destination ports of each session are not on the
same line interface board, only one session is allowed.
� This example describes how to set a session numbered 1, with
the source port fei_1/1, and the traffic collection direction Tx.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#monitor session 1 source direction tx
� This example describes how to set a session numbered 1, with
the destination port fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#monitor session 1 destination
show monitor session

mtu

Use this command to set the MTU of an interface.
Interface configuration
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Session number, ranging 1–8
Specifies the port as the destination port
Specifies the port as a source port
Specifies the traffic collection direction of the
source port
Sets the traffic collection direction of the
source port to both Rx and Tx
Sets the traffic collection direction of the
source port to Tx
Sets the traffic collection direction of the
source port to Rx
39