Purpose
Command Mode
Syntax
Syntax
Description
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
mac-learning mode
Use this command to configure the mode to learn a dynamic MAC
address on a physical port.
Interface configuration mode
mac-learning mode { ivl | svl}
ivl
svl
This example describes how to set the MAC address learning mode
as ivl.
ZXR10(config)#interface gei_1/2
ZXR10(config-if)#mac-learning mode ivl
mode
After the cpos3 interface is set to the SONET mode, use the m
ode command to set the work mode of the sts-1, and use the no
form of this command to delete all interfaces of the specified work
mode.
sts–1 configuration
mode {vt-15|vt-2}
no mode {vt-15|vt-2}
vt-15
vt-2
It is applied only to ZXR10 GER.
This example describes how to set the work mode of sts-1 to vt-15.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#sts-1 1
ZXR10(config-control)#mode vt-15
mode(CT1)
Use this command to configure the working mode of interface
board CT1.
Global configuration
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
It is to set the MAC address learning mode
as ivl.
It is to set the MAC address learning mode
as svl.
Sets the work mode of sts-1 to vt-15
Sets the work mode of sts-1 to vt-2
37