Front Panel Assembly (Pl 9.2.1.8) - Xerox Phaser 3425 Service Manual

2.
Rotate the rear cover until the flat surface of the left hinge pin (refer to standard
orientation drawing on page 8-2) aligns with the slot as shown in ➀ below. Pull
up on the left side of the cover to free the left hinge pin.
Slide the rear cover to the left to free the right hinge pin (see ➁ above), and
3.
remove the rear cover.
4.
If you are replacing the rear cover assembly, remove the strap for use on the new
cover assembly. Pry the top end of the strap off of the retaining boss on the rear
cover. Slide the strap down to remove it from the rear cover.

Front Panel Assembly (PL 9.2.1.8)

1. Remove the Print Cartridge (page 8-4) and protect it from light.
2.
Remove the Top Cover Assembly (page 8-9).
Service Parts Disassembly
1
2
-
8-15