Resetting Service Interval Display (Sid) Qg1 And Qg2 - Skoda Fabia 2000 Workshop Manual

FABIA 2000 Inspection and Maintenance
Note
♦
For vehicles with the dash panel insert 6Y0 920 xxx x,
the SID with the set button -1- cannot be reset before
a service is required.
♦
Always only reset the desired service interval („OIL
service" or „INSP service"), otherwise an incorrect
date for another service interval will be set.
–
Switch off ignition.
–
Press set button -1- and hold and simultaneously
switch on ignition.
–
As soon as the display „OIL service" appears, release
the set button.
–
Turn set button -1- to the right.
„- - -" appears in the display.
–
Move forward to the next service message by once
again pressing the set button -1-.
–
As soon as the display „INSP service" appears, re-
lease set button -1-.
–
Turn set button -1- to the right.
„- - -" appears in the display.
–
Switch off ignition.
Resetting service interval display (SID)
QG1 and QG2
The pre-information about an up-coming service will be
displayed 30 days before the service interval. The read-
out appears on the display for the kilometre counter after
switching on the ignition whereby the number of remain-
ing kilometres required to reach the distance interval will
be displayed for the first 10 seconds while the number of
days remaining to reach the time interval will be shown in
the next 10 seconds. This interval will reduce later in
steps while driving down to 1 day or 100 kilometres. This
display stops blinking after 20 minutes, after starting the
engine or after pressing the reset button of the short jour-
ney counter.
If the due date of a service is reached, the key symbol ap-
pears in the short journey counter below the speedome-
ter as a flashing display, after the ignition is switched on,
whereby there are no numbers displayed. The display is
accompanied by an audible tone signal. This display
stops blinking after 20 seconds, after starting the engine
or after pressing the reset button of the short journey
counter.
If no inspection service is made the display will appear in
a similar way to that for reaching the service interval but
minus values will be both displayed and accumulated.
Note
The pre-information display shows 30 days before the
due date of an inspection.
Edition 09.04
S00.5301.14.20
Electrical System
1
S02-0306
02-6
02
7
page