FABIA 2000
Inspection and Maintenance
02-6
Electrical System
Power windows: Inspecting positioning
If the battery is diconnected the power windows forget
their current position.
Test conditions:
•
All car doors closed
The inspection procedure is carried out from the outside
Close window with the car key using the convenience
closing system.
–
Turn car key into close position and hold until all the
windows are closed.
–
After closing the windows hold the key in the close po-
sition for approximately another 3 seconds.
Electrical components: Check for proper
operation
–
Inspect lighting, main headlights, headlight beam con-
trol, fog lights, turn signal lights, hazard warning light
system, tail lights, rear fog lights, reversing lights,
brake lights, parking light control for brightness and
proper operation.
–
Inspect interior lights, illuminated storage compart-
ment, illuminated ashtray for proper operation.
Airbag warning lamps: Check operation ⇒ Chapter
–
02-7.
–
Inspect warning buzzer, onboard computer, all switch-
es in centre console as well as on the dash panel and
horn for proper operation.
–
Inspect power windows, exterior mirrors (heated and
electrically adjustable), central locking system, infra-
red remote control and convenience closing system
for proper operation
–
Inspect heating of front seats for proper operation.
–
Inspect radio for proper reception and absence of in-
terference, also inspect speakers ⇒ 02-6 page 2.
Battery: Testing no-load voltage
Special tools, test and measuring equipment and
auxiliary items required
♦
Multimeter (e.g. -V.A.G 1526 A-)
Prior to the measurement the vehicle must have been in
the no-load state for at least two hours (no engine starts,
no charging or discharging of battery).
The following procedure applies to measuring the battery
voltage in the no-load state (after at least two hours):
–
With the battery installed measure the voltage be-
tween the terminals (ignition switched off).
Edition 09.04
S00.5301.14.20
Electrical System
02
02-6
1
page