Assembly - Star Trac Instinct Owner's Manual

W B I R
EIGHT ELT NSPECTION EQUIREMENTS
WARNING: REPLACE WORN WEIGHT BELTS IMMEDIATELY. FAILURE TO COMPLY CAN RESULT IN HAZ-
ARDOUS CONDITIONS FOR USERS OR OTHER BYSTANDERS.
Inspect all weight belts for evidence of excessive wear or other damage. Give particular attention to the following conditions:
14
Torn or cracked belt
Exposed belt cords
Worn edges
STAR TRAC INSTINCT CHEST PRESS O '
WNER S

ASSEMBLY

1. Assemble the Main Frame to
the Weight Frame
Align the two drilled holes in the lower cross-
beam (4) with the mating holes in the bottom
of the weight frame (1). Secure the crossbeam
to the weight frame using two screws (37), four
washers (51), and two lock nuts (49). Tighten
the nuts securely.
Align the two drilled holes in the upper cross-
beam (5) at the pulley end with the mating
holes in the side beam of the weight frame (1).
Secure the crossbeam to the weight frame
using two screws (37), four washers (51), and
two lock nuts (49). Tighten the nuts securely.
Position the main frame (2) so the two drilled
holes in the lower crossbeam (4) and the two
drilled holes in the upper crossbeam (5) are
aligned with the mating holes in the main
frame.
Secure the main frame to the lower crossbeam
using two screws (37), four washers (51), and
two lock nuts (49). Tighten the nuts securely.
Secure the main frame to the upper crossbeam
using two screws (37), four washers (51), and
two lock nuts (49). Tighten the nuts securely.
2. Install the Leverage Arm
NOTE: Two people are required to install the
leverage arm; one to hold the leverage arm in
position, and one to install the leverage arm
shaft.
Loosen the two setscrews (47) in each of the
two leverage arm shaft support bearings on
the main frame (2).
Hold the leverage arm (3) in position between
the two shaft support bearings.
Insert the leverage arm shaft (19) through the
leverage arm and both support bearings.
Secure the leverage arm shaft (19) to the main
frame (2) using two screws (43) and end caps
(17).
Tighten the two setscrews (47) in each of the
two leverage arm shaft support bearings on
the main frame (2).
Rotate the leverage arm back until it rests
against the stop on the main frame.
M STAR TRAC INSTINCT CHEST PRESS O
ANUAL
49
51
51
37
49
1 5
51
37
49
49
51
51
4
51
37
49
51
51
49
37
51
43
47
17
3
' M
WNER S ANUAL
51
2
51
37
51
51
51
37
2
47
19
17
43
7