A13.0 Flow Switch Illustration; A14.0 Sensor Harness Connector Diagram - Jacuzzi Premium J-325 Troubleshooting Manual

A13.0 Flow Switch Illustration

Flow Switch #6560-852
Compatibility: All 2004 J-315, J-325 Models
Connection: This fl ow switch style has spade connectors at the top for easy
cable removal for electronic troubleshooting.
Flow Switch #6560-860
Compatibility: All 2004 J-335, J-345 Models
Connection: This fl ow switch style has connectors that are potted into the top
and cannot be removed at the fl ow switch.
A14.0 ProTech LED Sensor Harness Diagram
J2 Connector (Cable Side)
Shown While Plugged Into The Circuit Board
Temperature
Sensor Wires
TINE
PIN
Hi-limit Sensor, Temperature Sensor,
And Flow Switch Wires
6560-860
Hi-Limit
Sensor Wires
PAPER CLIP
Connector
(Side View)
wire to be pulled from the harness.
Important!
When reinstalling the sensor/fl ow switch wire, make sure the
tine on the pin is lifted so the sensor wire will lock into the
connector body.
J2 Connector Flow Switch (Cable Side)
Shown While Plugged Into The Circuit Board
To remove a sensor/fl ow switch wire from ei-
ther the J2 or J3 connectors, insert the end
of a paper clip or similar device into the slot
corresponding with the wire to be removed.
This will depress the tine on the pin, allowing the
56
6560-852