A15 Flow Switch Illustration (Models With A Circulation Pump); A16 Pressure Switch Illustration (Models Without A Circulation Pump); A17 Sensor Harness Diagram - Jacuzzi LED Series Manual

A15 Flow Switch Illustration (Models with a circulation pump)

Flow Switch #6560-852
• 2011-2013 J315, J-325 Models
Connection: This flow switch style has spade connectors at top for easy cable removal for
electronic troubleshooting.
Flow Switch #2560-040
• 2011+ JLX
• 2011-2013 J300 (except J-315 and J-325)
• 2011-2012 J-230, J-270, J-280 (with Circulation Pump)
Connection: This flow switch style has cable with curled finger connectors that can be removed from plug for
electronic troubleshooting.

A16 Pressure Switch Illustration (Models without a circulation pump)

Pressure Switch #6560-869
• 2012+ J J-235, J-245, J-275
• 2011+ J-210, J-280
• 2011-2012 J-230, J-270
Connection: This pressure switch has spade connectors at top for easy cable removal for elec-
tronic troubleshooting.

A17 Sensor Harness Diagram

J2 Connector (Cable Side)
J2 Connector (Cable Side)
Shown while Plugged into Circuit Board
Shown while Plugged into Circuit Board
J2 Connector (Cable Side)
Shown while Plugged into Circuit Board
Temperature
Temperature
Sensor wires
Sensor wires
Temperature
Sensor wires
TINE
PIN
PIN
Hi-limit Sensor, Temperature Sensor,
Flow Switch Wires
Hi-limit Sensor, Temperature Sensor,
Flow Switch Wires
Hi-limit Sensor, Temperature Sensor,
Hi-limit
Hi-limit
Sensor wires
Sensor wires
Hi-limit
Sensor wires
Paper Clip
Connector
TINE
(Side View)
PIN Connector
(Side View)
TINE
Connector
(Side View)
2560-040
J3 Connector (Cable Side)
Shown while Plugged into Circuit Board
Shown while Plugged into Circuit Board
• Flow Switch
• Pressure Switch
To remove a sensor/switch wire from the either J2 or J3
Paper Clip
connectors, insert the end of a paper clip into the slot cor-
responding with the wire to be removed. This will depress
the tine on the pin allowing the wire to be pulled from the
Paper Clip
harness.
IMPORTANT!
When reinstalling the sensor/switch, make sure the tine on
the pin is lifted so the sensor wire will lock into the connector
body.
6560-852
J3 Connector (Cable Side)
Shown while Plugged into Circuit Board
J3 Connector (Cable Side)
P
S
I
57