Chapter 4: Power Up; Ac Input - Avaya P333T-PWR Quick Start For Hardware Installation

Chapter 4: Power Up

Connecting the P333T-PWR to the main electrical supply provides power to the switch.
!
VOLTAGE ALERT:
To isolate the switch completely, you must disconnect all power connections: AC
VOLTAGE ALERT:
plug or DC terminal block and DC BUPS power.

AC input

1. Insert the power cord into the power connector (BUPS or Power Supply) on the rear of the
unit.
Figure 4: P333T-PWR rear panel
2
Figure notes:
1. BUPS connector
2. AC connector
2. Insert the other end of the power cord into the electricity supply or the BUPS connector.
- The unit powers up and performs a self test procedure. The LEDs flash at regular
intervals after the self-test procedure is completed successfully.
1
Issue 1 September 2005 19