Epson Stylus CX7300 Service Manual page 127

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
2. Remove the screws (x2) that secure the ASF Unit.
2
Figure 4-84. Removing the ASF Unit (1)
3. Release the dowel (x1) and guide pins (x2) of the Base Frame and the shaft
(x1) of the ASF Unit, then remove the ASF Unit.
Guide Pin and Positioning Hole
Figure 4-85. Removing the ASF Unit (2)
DISASSEMBLY/ASSEMBLY
ASF Unit
1
C.B.P. 3x8, F/Zn-3C (6±1kgfcm)
ASF Unit
Dowel
Shaft
Disassembling the Printer Mechanism
When installing the ASF Unit, be sure to align the guide pins
(x2) of the Base Frame with the positioning holes (x2) of the
ASF Unit as shown in
Tighten the screws in the order given in
When routing the PE Sensor cable, pay attention to the
following instructions.
• Route the cable in the order given in
• Make sure to attach the cable with the blue line facing
toward the Base Frame.
Figure 4-86. Routing PE Sensor Cable
Check that the cable is tightly routed and there is no slack of
•
it.
Whenever the ASF Unit is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Chapter 5 " ADJUSTMENT" (p.141)
•
Figure 4-85.
Figure 4-84.
Figure 4-82.
PE Sensor Cable
Confidential
127