Epson Stylus CX7300 Service Manual page 106

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
When installing the Power Supply Unit, make sure to check the
following points.
Insert the tabs (x2) of the Power Supply Unit into the holes on
the Base Frame.
bottom
Figure 4-28. Installing the Power Supply Unit
Tighten the screws in the order given in
Secure the Power Unit Cable with the hook of the Base Frame
as shown in the figure below.
Put the ferrite core of the Power Supply Unit cable into the
cutout of the Base Frame.
Ferrite Core
Base Frame
Figure 4-29. Routing the Power Unit Cable
DISASSEMBLY/ASSEMBLY
Power Supply Unit
Base Frame
Ribs
Figure 4-27.
Power Unit Cable
Hook
Removing the Circuit Boards
Whenever the Power Supply Unit is removed/replaced, the
A D J U S T M E N T
R E Q U I R E D
required adjustments must be carried out.
• Chapter 5 " ADJUSTMENT" (p.141)
106
Confidential