Built-In 55 Cm; Substructure - Electrolux GS 23 CH Service Manual

1.4

Built-in 55 cm

1.4.1 Substructure

Dishwashers GS 24 (lower and medium comfort level) G 4 5x / G4 6x
General
- The dishwasher is supplied ready for
installation, i.e. with power cable, mounted
discharge hose and admission hose with sieve.
- The dishwasher may be built into niches made
of combustible material without additional safety
measures.
- Provide water tap and socket as indicated in the
drawing opposite.
- Always observe the regulations of the local
waterworks and electrical power supply
facilities!
Do not lay down the appliance! The built-in water
softener contains water which could drain off.
Water installation
Inlet
- You may connect the appliance to both cold and hot water (max. 65 °C).
- Water pressure: 1 to 10 bars (flow pressure)
- A regulating tap of outgoing connection G ¾" should be provided by the Customer.
- The inlet hose is a plastic compression hose with sieve, SVGW approved 25 bars.
- It is recommended to install an IRG filter.
Drainage:
- Install the flexible drainage hose of an inner diameter of 22 mm without buckles.
- The drainage of the appliance is provided with an Aqua-Stop system so that connection
fittings with anti-reflux device are not required.
- The highest point of the drainage hose may never exceed 700 mm above floor level.
Spares Operation 07.02 A. B.
A =
G =
K =
N =
W =
E =
- 8 -
Drain
Appliance dimensions
Cold water connection
Niche dimensions
Hot water connection
Socket
599 51 13 34 EN