Electrolux GS 23 CH Service Manual page 12

Electrical connection
A licensed electrical fitter should install the connection
to the mains !
- The appliance is provided with a power cable 3 x 1
mm2 with injection-moulded plug (type 13).
- You should connect the dishwasher to the mains by
means of a plug, or an all-polo-switch of a
minimum of 3mm contact distance should be
provided within the fixed installation for isolation
from the mains.
Installation on the part of the customer :
- Install fuse, feeder and socket according to the
wiring schematic.
- Connect plug (supplied by Customer) according
to instruction label on power cable.
Switching over to 230 V 6 A, 15 kW
Should be carried out by a licensed electrical fitter!
- Isolate appliance from the mains.
- Unscrew front panel (F).
- With the non-incorporated dishwasher, remove
all screws (X6),
- With incorporated and fully incorporated
dishwashers with two-piece door panel, remove
the 4 outer screws of X6 only.
- Attention: Do not remove screw (S).
- Unscrew lower cover (A) and disengage.
- Switching over according to connection
schematic on the inner face of the servicing
cover.
For switching over to 230 V, 1150 W, 6 A, refer to connection schematic on the inner face of the servicing
cover. Plug schematic identical to 230 V, 2150 W, 10 A.
Spares Operation 07.02 A. B.
Circuit: Radiator voltage 230 V
Only recommended for hot water connection.
- 12 - 599 51 13 34 EN