Computer Pretest - Electrolux GS 23 CH Service Manual

5.7

Computer Pretest

Application:
Start:
Stop (main switch):
Sequence:
Spares Operation 07.02 A. B.
This Pretest was developed for the test bench in the works
and can also be used in the field (best along with a
transparent door). All electrical components in the
machine are controlled.
Switch OFF main switch
Close door
The following key combinations are applicable for the following
control systems:
Press and hold
2 keys / PNC 153 0259-08/2: Programme selection (LED Eco
and intensive)
5 keys / PNC 153 0259-05/8: Eco and intensive
8 keys / PNC 153 0259-09/0 Half-load and Short together
Switch ON main switch
Hold the key(s) pressed for at least 5 sec (corresponding LEDs
are flashing during this time)
The display shows the upper circle of the number 8 and/or the
corresponding LEDs are permanently lit
The programme starts to run
If you stop the programme by means of the main switch, you
can immediately select a wash programme when switching ON
again.
If you start the pretest again - as described under Start - the
programme jumps directly to Step 9, first pumping the water off
the trough (corresponding LEDs flashing at the end).
Now you can restart the pretest - as described under Start.
See attached sequence plan.
- 36 - 599 51 13 34 EN